Centro Natural Gas Conversion Kit Operations Instructions download pdf (Page 10)

Lighting the Side Burner

Use the Electronic Igniter on the main control panel and the Side Burner control knob, on

the far left panel, to light the side burner.

•

Push in and turn the side burner control knob to the HIGH position.

•

Push the igniter button.

•

If the burner does not light, turn the control knob to the

OFF position and wait 5 minutes for the gas to clear.

•

Repeat the above instructions. If the side burner still does not light,

refer to the troubleshooting section for help or light the burner manually.

Note: The side burner is designed to accept a maximum weight of 20 lb. Do not overload

the side burner.

Lighting the Side Burner with a Match

•

Place match in front ring of provided match holder.

•

Place a lighted match through the hole to within 16 cm (1/2˝ ) of the side burner.

•

Push in and turn the burner knob to the “HIGH” position. At this point,

the burner should light, if it doesn’t after 5 seconds, turn the

control knob back to the “OFF” position and wait for the gas to clear.

•

Wait 5 minutes, and then repeat the manual lighting procedure. If after three

tries the burner still does not light, review the troubleshooting guide for help.

Visually Check Burner Flame

Take off the grates and flame tamers. Light burners. Adjust the flame by turning the knobs

from “HIGH” to “LOW”. The flames will be smaller when the knobs are in the “LOW” posi

tion. Always check flame prior to each use. Perform flame check for side burner.

HIGH

LOW

1 ... 9 10 11 ... 32

No comments

Centro Natural Gas Conversion Kit Operations Instructions Page 10