Centro 85-1620-6 User Manual

W A R N I N GFailure to follow all of the manufacturer’s instructions could result in hazardous fires, explosions, property damage, or serious person

8A S S E M B L Y I N S T R U C T I O N S 1Remove warming rack, cooking grates, flame tamers, and control knobs from Centro 6000SI BBQ.

9 2Remove all burners including the 3 main U burners, by unscrewing the screw and nut that affix the burner to the burner support bar, as shown in Fig

1 0 4Using the Orifice removal tool provided, insert into hole on the rear of the control panel (Fig. A and B), inside the burner box. Tool will fit d

1 1 5Replace Rotisserie and Sear Zone Control knobs (Figure A). Only the 3 Main Burner Valves must be worked on in this step. Using the screwdriver to

1 2 6 7Multi-Purpose Side Burner Orifice Replacement a) Remove side burner grate and control knob (Fig. A and B).b) Disassemble the garbage door and g

1 3 8Remove the side burner from the unit (Fig.A).Fig. 8Using the orifice removal tool, remove the side burner valve orifice (Figure B). (View from i

1 4 10Rotisserie Burner Orifice ReplacementUnscrew the 5 screws and nuts of the Rotisserie Burner from the Rear Windshield Cover, located on the back

1 5 12Unscrew the Wing nut by hand so that the orifice can be taken out from the Rotisserie Burner Venturi (Figure A). Result shown in Figure B. Use t

1 6 13Gas Supply ConversionUsing a wrench, remove the hose and regulator inside the cart, as shown in Figure A. Then connect a NG hose and perform lea

1 7Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8D I S T R I B U T O R

 W A R N I N G Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.i i• This kit converts

 W A R N I N G 1U S E A N D C A R ENatural Gas Connections and Service Regulators Above 1/2 psi. Prior to 1998, all residual gas service regu

2C O N N E C T I N G Y O U R G R I L L T O T H E N A T U R A L G A S S O U R C E1. A professionally-installed shut-off valve between the

34. When the quick disconnect socket and the gas hose are connected, a valve in the sock-et opens automatically to permit full gas flow. When the gas

4Although all gas connections on the grill are leak tested at the factory prior to shipment, a COMPLETE gas tightness check must be performed followin

5Storing Your Grill• Clean cooking grates.• Store in dry location.• Cover grill if stored outdoors. Choose from a variety of grill covers offered by

6

7P A R T S L I S T A N D D I A G R A M ( 8 5 - 1 6 2 1 - 4 )The Natural Gas Conversion Kit includes:1. NG hose2. Orifice removal tool3. Screw