Centro Barbecue 3000 Safe use Technical Information download pdf (Page 4)

User’s manual

skills, please disconnect power and activate the safety device. However, the user must take all necessary safety precautions,

in particular when working on the bottom of the lawnmower robot, following procedures indicated by the manufacturer.

•

Use the personal protection devices recommended by the Manufacturer, in particular, always wear protective gloves when

handling the cutting blade.

•

Before replacing the batteries, always remove the blade.

•

Make sure the air vents of the power supply unit are free and clear of residuals.

•

To avoid irreversible damage to the electric and electronic parts, do not wash the robot with water jets at a high pressure and

do not immerse it in water, partially or completely, as it is not watertight.

•

Operators who perform repairs during the working life of the robot must have the necessary technical expertise, skills and

experience in this specic eld. The lack of these requirements may be hazardous to the health and safety of people.

•

Inspect the robot at regular intervals to ensure that the blade, the assembly screws and the cutting mechanism are not worn

or damaged. Replace badly worn parts using original spare parts to ensure proper function and the required safety level.

•

Make sure that all nuts, bolts and screws are tightened to ensure that the robot is in good operating conditions.

•

The robot cannot be used without the top cover. If the mechanical parts of the robot are damaged, replace them.

•

Any routine or extraordinary maintenance (e.g. battery replacement) must be performed by an authorised service centre.

•

The Manufacturer shall not be held liable if non-original spare parts are used.

•

Never use and recharge the robot in explosive and/or ammable environments.

•

To recharge the robot, use only battery chargers and power supply units provided by the supplier. Improper use may cause

electric shocks, overheating or leakage of corrosive liquids from the battery. If any liquid leaks, the battery must be washed

with water / neutraliser; seek medical assistance for contact with the eyes.

SAFETY DEVICES

1. Bumpers

The bumper sensor is activated if the robot strikes a solid object greater than 9 cm (3.54 ") in height, which stops the movement

in that direction and moves backwards to avoid the obstacle.

2. Inclinometer

If the robot works on a slope which is steeper than the maximum limit, or tips over, the robot will stop the cutting blade.

3. Emergency stop switch

Located on the control panel with the word “STOP” larger than the other commands on the keypad. Pressing this button at any

time during operation will immediately stop the movement of the lawnmower robot and the rotation of the blade will stop within

2 seconds.

4. Over-current protection

Each motor (blade and wheels) is monitored continuously during operation for any situation that may cause them to overheat. If

this occurs in the wheel motor, the robot will attempt to move in the opposite direction. If the over-current persists, the robot will

stop and signal an error. If the cutting blade motor overheats, there are two intervention ranges. If the parameters fall within the

rst range, the robot will perform the manoeuvres to unblock the cutting blade. If the over-current is below the protection range,

the robot will stop and signal a motor error.

1 2 3 4 5 ... 32

Comments to this Manuals

No comments

Centro Barbecue 3000 Safe use Technical Information Page 4

Comments to this Manuals

Related products and manuals for Barbecues & grills Centro Barbecue 3000 Safe use